Re: Change view in ALV by code

Hi,

Check this code:

DATA: lt_alv_views        TYPE wdr_pers_variants,
      ls_param_out        TYPE if_salv_wd_table=>s_type_param_config_out,
      ls_param_in         TYPE if_salv_wd_table=>s_type_param_config_in.

FIELD-SYMBOLS: <ls_alv_view>            TYPE wdr_pers_variant.

ls_param_in-action = if_salv_wd_table=>list.
ls_param_out       = lo_comp_if_alv->get_config_data( ls_param_in).

lt_alv_views[]     = ls_param_out-t_view_list[].

READ TABLE lt_alv_viewsASSIGNING <ls_alv_view> WITH KEY description = 'FULL'.
IF sy-subrc= 0.
  ls_param_in-action = if_salv_wd_table=>set.
  ls_param_in-view   = <ls_alv_view>.
  MOVE-CORRESPONDING <ls_alv_view> TO ls_param_in-config_key.
  ls_param_out       = lo_comp_if_alv->get_config_data( ls_param_in).
ENDIF.

Best regards,

Guillaume